Page 28 - Mercury Service Tool Guide (2021) - 8M0174458

BRAVO STERNDRIVE

SPLINE BACKLASH TOOL END CAP TOOL

91-806192 91-821709T
Measures the propeller shaft to gear spline backlash on V‑blocks. Trim Cylinder End Cap Tool
Allow easy removal of the trim cylinder end caps. Required if tilt limit spacers are
BEARING DRIVER KIT to be installed or if the trim in limit spacer is to be removed to allow additional trim
in range.
DIAL INDICATOR ADAPTER

91-8M0156977
Installs the U‑joint oil seal into the bearing carrier. Also used to pilot the puller rod
for the installation of the gear housing needle bearing.
Bravo One, Two, and Three. Shim included for use with Bravo X drives.
GUIDE PLATE BRAVO STERNDRIVE

91- 83155
Dial indicator holding fixture.
SHIFT CABLE DRILL BUSHING KIT

91-816243
Centers the rod used to drive in the forward gear bearing on a standard rotation
gearcase and the reverse gear bearing on a counter‑rotation gearcase.
SLEEVE INSTALLATION TOOL

91-818836A 1
Aids in replacing a shift cable in bell housing to enlarge hole to .4375 inch for new
cable.
Bravo Drive ‑ S/N 0D542204 and below.
BEARING AND SEAL INSTALL TOOL

91-818162
Installs the aluminum sleeve into the U‑Joint bellows.

91-840385
Installs the needle bearing and oil seals into the bearing carrier.

Mercury Service Tool Guide 21