Page 55 - 2017 Product Guide

INSULATION | ECONOBOARD INSULATION

Without insulation boards With insulation boards
Without insulation boards heat energy is lost into the Econoboard reflects the heat energy up through
substrate before radiating up through the floor into the floor resulting in increased efficiency and much
the room. This is wasted energy. lower running costs.

Water and rot proof Suitable for stud partition walls Provides stability for tiling
Econoboard Coated is a 100% water proof Econoboard Coated (min. thickness of 10mm) Econoboard Coated is reinforced to provide
alternative to ply wood. It provides floor is suitable for use on stud partition walls where stability to timber floors before tiling. The
insulation properties, lateral stability and won't the studs are set at 300mm centres. All board extruded polystyrene layer insulates the floor
rot if it comes into contact with water. The edges must be supported by timber noggins ensuring optimum efficiency.
ideal solution in bathrooms or with any timber and fixed with fixing screws and washers set at
substrate, and can also be used as part of a 300mm centres around the board.
wetroom solution.
Econoboard™ Coated installation onto timber substrates

Installation method

1. Cut boards to size using a sharp blade
2. Lay boards in an offset brick pattern
3. Fix in position using washers and
screws (10 washers per board)
4. Ensure joints are closed
(Seal with tape if required)

Econoboard™Uncoated installation onto a concrete substrate

Installation method
1. Cut boards to size using a sharp blade
2. Spread flexible adhesive over the floor
3. Lay the boards in a brick work pattern
4. Ensure joints are closed
(Seal with tape if required)

FREE DELIVERY ON ALL ORDERS OVER $250.00 RRP E&OE ©THERMOGROUP 55