Page 33 - CloudCuddle Handleiding

II. USING THE CLOUDCUDDLE EN

A. Important instructions 4. Checks after setup • White sliders: the sliders are tight together and the pull-tabs lie flat against the zipper. 6. Washing the CloudCuddle
This ensures that the zipper is extra constrained and difficult to open from the inside. • Do you want to wash the entire CloudCuddle? Make sure to remove the black,
1. Before first use Perform the following checks after you have fully set up the CloudCuddle. If the CloudCuddle The best position is along the top edge, as shown in the picture below inflatable tubes from the cover before washing! The black, inflatable tubes should not
• In order to make the situation more familiar to your child, you can wash the sheet fails to match the description for one or multiple of the steps below, we advise against using be machine washed. Make sure all zippers and buckles are closed before you start
or the entire CloudCuddle beforehand to give it a recognisable smell. Remember to it. washing.
remove the inflatable tubes first. These should not be machine washed! View chapter
II, D: Washing the CloudCuddle. • Tubes: the tubes have been sufficiently inflated: you cannot dent the tubes and you • The sheet can be washed separately at 60 degrees (view care label).
hear a clear ‘pock pock’ sound if you tap them with your finger.
• We recommend you use the CloudCuddle for a few nights at home before • The rest (tube cover + mattress cover) can be washed at 30 degrees (view care label).
bringing it on vacation. • Bed frame: the bed frame is heavy enough; it is not possible for your child to tilt the
bed along with the CloudCuddle.
7. Storage
2. Before every use • Buckles: all buckles on the straps are closed. Both those on the straps under the • Fold the CloudCuddle by following the instructions in this manual (view chapter II,
• Inflate the CloudCuddle and leave it for at least three hours to check if it is still in good mattress as well as those on the straps on the bed frame. C: Deconstructing the CloudCuddle). Make sure the sheet is clean. If you want, you
condition and does not deflate, for example. can remove the sheet to wash it and store it separately. Place the CloudCuddle in the
• Bed frame straps: the straps that connect the CloudCuddle to the bed frame are at full included bag and store this in a dry space at room temperature.
• Check all fabric parts for damage. tension and cannot slide. When in doubt, we strongly urge you to place the mattress • Mesh: there are no gaps or tears in the mesh.
with the CloudCuddle on the floor. If the CloudCuddle cannot be properly attached to • Don’t put heavy objects on top of the CloudCuddle when travelling or when you store
the bed frame, dangerous situations may arise. • Snap fastener: the snap fastener at the top of the tube cover is closed. it. In a plain you can take the CloudCuddle with you as medical hand luggage.
3. Inflating CloudCuddle
• Check if the pump hose is connected to the INFLATE side. • Zippers: all zippers are closed: this includes both the zippers on the tube cover and • Valve: both valve caps are properly closed; no air can escape.
the zippers on the transparent mesh.
• The CloudCuddle should be inflated properly (view the instruction video on the • CloudCuddle sheet: the CloudCuddle is provided with a replaceable sheet (you can
website / under the header ‘product / use’). If the CloudCuddle is not sufficiently unzip this sheet).
inflated, it does not offer the protection that is required. A CloudCuddle is properly
inflated if you cannot dent the tubes. We recommend using a pressure meter. The • Tube clips: the clips on the connections between the tubes are closed.
recommended pressure is 0.45 bar (6,5 psi*). This pressure is best achieved using the
CloudCuddle pump. Keep pumping until you really can’t add any more air, then you’re
sure you’ve reached the right pressure. Do not use a higher pressure pump to avoid 5. Deconstructing the CloudCuddle
damaging the frame. • Deflate the CloudCuddle by unscrewing the rear valve cap. Keep in mind that the air
in the tubes is under pressure, and will release with a firm pop when you unscrew the
• Do you use an electric pump? Check carefully if it can deliver the right pressure. Many cap.
electric pumps have too little power! This results in a soft frame that is too weak and
offers less protection. • Check if the clips on the connection tubes are opened. If the clips are closed, the air
cannot leave the rear sections of the tubes.
• Never put the pump in the bag together with the CloudCuddle. Sharp edges can
damage the mesh.
HARD

*psi = Pound per Square Inch
30 31