Page 34 - CloudCuddle Handleiding

EN EN

B. Setting up the CloudCuddle B. 9. At the top of the inflatable frame, where the tubes cross, are clips that can be used to
close the connection between the tubes (also view step 5). Squeeze these shut (view
Our website features an instruction video (www.cloudcuddle.com, under ‘product/use’). You photo 19).
can also directly go to YouTube and search for ‘set up CloudCuddle’. The instruction video
serves as an illustration and addition to this manual, but is not a replacement. 10. Only use this step on a bed frame. Every corner of the CloudCuddle has a strap with
a click buckle. Place the straps around the bed frame and close the buckles. Tighten
the straps so they cannot slide (view photo 20).
1. Take the CloudCuddle from the bag and unroll it.
11. The CloudCuddle has now been set up (view photo 21).
2. Fold the cover around the mattress cover as a fitted sheet (view photo 14). The
corners should be properly tucked around the corners of the mattress. In the Photo 14: fold cover around mattress. Photo 15: attach and tighten straps. Photo 20: close buckles and remove straps. Photo 21: ready!
beginning, the cover will fit the mattress tightly. This means the CloudCuddle fits
around the mattress with the right tension, so the strength of the construction is C. Deconstructing the CloudCuddle
guaranteed. C.
1. Open the buckles and remove the straps (view photo 22).
3. Tilt the mattress in order to attach the straps below the mattress. The straps have click
buckles (view photo 15). Tighten the straps by pulling the loose end (which extends 2. Open the snap fastener at the top of the cover (view photo 23).
from the click buckle).
3. Open the clips located where the tubes cross (view photo 24).
4. Find he valve in the white sock on one of the legs and unscrew the front square cap
(view photo 16). Make sure the rear valve (round, with serrated edge) is properly 4. Open the valve by unscrewing the rear, serrated ring and deflate the CloudCuddle
screwed on. (view photo 25). Do not be alarmed: due to the pressure, the air will release with a
firm pop.
5. Before inflating, check if the tube clips are open (you can find the clips under the cover, Photo 16: unscrew the front cap. Photo 17: open clips where the tubes cross. Photo 22: open buckles and remove straps. Photo 23: open pushbutton on top.
where the tubes cross) (view photo 17). 5. Undo the straps below the mattress by opening the buckles (view photo 26) and
remove the CloudCuddle from the mattress.
6. Do you own a CloudCuddle pump? Select the largest, square attachment with interior
screw thread. Connect this attachment to the inflating hose of the pump and screw the
attachment onto the CloudCuddle valve opening (see photo 18). Attach the other end
of the hose to the pump (at the INFLATE side).
7. Inflate the CloudCuddle to the correct pressure of 0.45 bar (6.5 psi). You will hear the
air flowing through the tubes. You reach the right pressure by using the CloudCuddle-
pump and continue pumping until you really can’t add any more air. The tubes are stiff
and you can’t press them anymore. If possible, check the pressure using a pressure
meter (manometer).
Photo 18: attach pump to valve. Photo 19: close clips. Photo 24: open clips. Photo 25: open rear valve cap to release air.
8. Straighten the fabric around the inflated tubes. The zipper of the tube cover should be
against the seam of the inflatable tube.

32 33