Page 733 - CarrLaneCatalog_2019ed-c.pdf

Tubing Installation

Tubing Benders
Drill Bit Deburring Tool
deburrs O.D. and I.D. simultaneously,
CLR-100-TL
Tubing Cutter adjustable chamfer, 50-200 rpm PART NO. For Tube O.D.
CLR-401-TL 1/4”
PART NO. For Tube O.D. Shank Ø
Cutting
CLR-402-TL 5/16”
1. Use only steel tubing as specified on CLR-202-TL 1/4” 1/4” CLR-403-TL 3/8”
the previous page. CLR-203-TL 5/16” 5/16”
2. Cut tubing with a tubing cutter or CLR-204-TL 3/8” 3/8” The Roemheld tube bender shown is a simple,
hacksaw. effective bender we highly recommend. When
3. File or sand tubing end square. End CLR-201-TL bending tubing carefully avoid wrinkling, flattening
must be square to achieve a proper Hand Deburring Tool or kinking the tube. Please note: complete flaring
flare. I.D. & O.D. 1/4” - 1-1/2” pipe before bending.
Maximum Minimum 4 Ft. Max.
Flare Flare
(1)

(2)
(3)
CLR-300-TL
Flaring Tool
Flaring (4)
1. Place nut and sleeve over tube before flaring.
Installation
2. Place tube in flaring tool, approximately 1/8" above top of block.
We recommend using tubing clamps as this will increase the life of
3. Clamp assembled block in vise.
the installation. Tubing clamps should be less than four feet apart
4. Center pin guide of flaring tool in tube. (Figure 1) and bends should be supported also (Figure 2). Use bends
as shown in Figures 3 and 4 instead of straight-line connections to
5. Strike flaring tool 3-4 times with sharp hammer blow. Remove from
block. prevent stressing the tubing.
6. Inspect flare so that their outside diameters extend beyond the Important: Never use tubing lines as handles to lift fixtures.
inner lip of the sleeve, but not beyond the sleeve’s OD.

1-1/8
3/8 3/8
1-7/16
1-1/16 3/4 13/16
13/16

3/4
1-15/32
Assembly Twin Tubes
1. Slide nut and sleeve on to flared tubing end Single Tube Regular and Stack Mounting
and finger tighten. Regular and Stack Mounting CLR-3300-891-TA Twin clamp
2. Finish tightening with a wrench, 1/4 to 1/2 CLR-3300-892-TA Single clamp CLR-3300-607-TA Twin mounting plate
turn. CLR-3300-600-TA Single mounting plate CLR-3300-609-TA Washer
CLR-3300-225-TA Mounting screw CLR-3300-225-TA Mounting screw
Note: Do not over torque. CLR-3300-604-TA Stack-mounting screw CLR-3300-613-TA Stack-mounting screw 14
CLR-3300-335-TA Stack-mounting clip CLR-3300-615-TA Stack-mounting clip

Subject to change. For further details, including detailed dimensions and mounting instructions, visit roemheld-usa.com.
Carr Lane Roemheld Mfg. Co.
Sales — Phone (314) 647-6200 Fax (314) 647-5736
Engineering — Phone 1-800-827-2526 Web roemheld-usa.com
8/18 731