Page 17 - Installation Manual - GenII DTS

Console Mount ERC—Single Handle
7. Use the supplied hex wrench to tighten the set screw inside the port rear corner of the ERC.

72664
8. Connect the ERC harness to the helm harness: green connector to green connector and blue connector to blue connector.
NOTE: The following is a partial architecture diagram, showing only the ERC connections.

b
a - Helm harness
b - Blue connectors (8‑pin)
a d c - Green connectors (12‑pin)
d - ERC harness
c
71141
9. Adjust the handle friction and detent as required, using the supplied hex wrench and the adjustment screws at the front of
the ERC.

a - Detent adjustment screw
b - Friction adjustment screw
a

b

71262
10. Install the access cover onto the ERC.

a
a - Hook on the access cover
b - Slide hook into the ERC body
c - Pivot the access cover downward to snap into
place
b

c

71763

90-8M0161677 eng MARCH 2021 © 2021 Mercury Marine Page 2B-3