Page 355 - REPOWER REFERENCE GUIDE (2020)

Instrumentation and Controls

• The shift cable brass barrel must be adjusted as stated in the engine installation manual.

a - Shift cutout switch plunger pin

a

7891
• While shifting into the same gear (and rotating the propeller shaft), the clutch must engage completely by the time that the
remote control is in the full reverse (with RH drive) or forward (with LH drive) position. Move the shift lever adjustable stud
up the slot if needed.
NOTE: The stud should be positioned at the bottom of the slot unless additional travel is needed.

a - Adjustable stud

a

13432
BRAVO SHIFT CABLES

• An adjustment tool is provided with the engine to allow the shift cables to be adjusted without the drive installed.

90-8M0149179 eng NOVEMBER 2018 © 2019 Mercury Marine Page 9D-11